The hyb series high pressure steam jet liquefier in the steam pressure for steam pressure is greater than or equal to 0.6MPa, jet liquefaction process can form high strength micro turbulence. Starch dispersion effect is good, liquefaction completely. At the same time, the demand for feed pump is low, and the energy consumption is low. High purity of saccharified liquid has no insoluble starch granule, protein aggregation effect is good, cut of starch and protein separation effect Yehao. Through the liquid jet, together with protein together, float on the water, sugar solution filtration speed. Eliminating the phenomenon of the end of the end of the liquid due to the end of the end of the liquid caused by the uneven heating of the liquid. Change in the protein is difficult to solidification, sugar is difficult to be filtered and proteins, cleaning paste mixed in sugar, resulting in fermentation bubble increased and influence after the procedure of the extraction and purification of liquid poor quality production.

Jet liquefaction continuous, non clogging. High-pressure steam jet liquefier from the principle and the structure of the complete elimination of blocking phenomenon, in slurry with whole grain rice grains and starch concentration is more than or equal to 22Be of, nor may jam; from the point of view of the manufacturer of the usage, the use of within 2 years of jet liquefier does not need to be disassembled to clean up. Eliminates the past domestic jet liquefaction due to jet aperture and other reasons, especially with superheated steam injection, frequently blocked and can not continuously produce defects.

The high-pressure jet liquefier with steam strip of, the driving force for high pressure steam, high-pressure steam to animal material so that the liquefaction is more uniform, more fully, at the same time, because of a feed pump lift requirements low can further save energy, make the cost lower again.

Please note when using:

1 ejector steam inlet and feed inlet need to be installed vertically.

0~1MPa pressure gauge is required to be installed in the steam chamber and the liquid chamber of the 2 ejector. Electronic thermometer installed at the thermometer interface 0~105.

3 to avoid jetting nozzle are rope, and other debris blocked, should be in into the mixing tank installed in addition to slag basket (screen 14 orders, 16 orders / inch).

High consistency pump 4 starch milk feeding pump adopts the working pressure greater than 0.6Mpa.

5 the device is suitable for the 30~40% concentration of starch milk. According to the process requirements to adjust the pH value, such as the required enzyme preparation.

6 adjusting the feed valve of the steam valve, the temperature of the liquid outlet is to reach the technological requirement.

7 rinse with water after the end of liquefaction, keep clean.